How to Replace a Serpentine Belt on a 2007-2013 Toyota Tundra in 15-20 Minutes
Introduction
Replacing a serpentine belt is a relatively simple task that can be completed in 15-20 minutes. A serpentine belt is a single, continuous belt that drives multiple accessories on your engine, such as the alternator, power steering pump, and air conditioning compressor. Over time, serpentine belts can wear out and need to be replaced.
Tools and Materials
You will need the following tools and materials to replace the serpentine belt on your 2007-2013 Toyota Tundra:
- New serpentine belt
- 1/2-inch drive ratchet
- 15mm socket
- Jack and jack stands
Safety First
Before you begin, make sure to park your Tundra on a level surface and engage the parking brake. Allow the engine to cool down completely before starting work.
Step-by-Step Instructions
- Locate the serpentine belt. It is located on the front of the engine and is wrapped around the crankshaft, alternator, power steering pump, and air conditioning compressor.
- Loosen the tensioner pulley. The tensioner pulley is located at the top of the engine. Use a 1/2-inch drive ratchet and a 15mm socket to loosen the tensioner pulley.
- Remove the old serpentine belt. Once the tensioner pulley is loose, you can remove the old serpentine belt by slipping it off the pulleys.
- Install the new serpentine belt. Route the new serpentine belt around the pulleys in the same way that the old belt was routed. Make sure to follow the routing diagram on the back of the new belt.
- Tension the serpentine belt. Use a 1/2-inch drive ratchet and a 15mm socket to tension the serpentine belt. The belt should be tight enough to prevent it from slipping, but not so tight that it causes damage to the pulleys.
- Tighten the tensioner pulley. Once the serpentine belt is tensioned, tighten the tensioner pulley. Use a 1/2-inch drive ratchet and a 15mm socket to tighten the tensioner pulley.
- Double-check the belt tension. Use a serpentine belt tension gauge to double-check the belt tension. The belt tension should be within the manufacturer's specifications.
Conclusion
Replacing a serpentine belt on a 2007-2013 Toyota Tundra is a relatively simple task that can be completed in 15-20 minutes. By following these step-by-step instructions, you can save yourself time and money by doing the job yourself.
Comments